In a message dated 07/12/1997 22:08:05, [email protected] writes: << [email protected] >> I found this really interesting and so far have eagerly await others comments to no avail. Personally I think the cost quoted are low, and if the job goes ahead would be interested in knowing what the final result was like, and who did it. Peter Howells
-- BEGIN included message
- To: <[email protected]>
- Subject: Lower rear wing repair
- From: "David Sims" <[email protected]>
- Date: Sun, 7 Dec 1997 21:49:22 -0000
- Content-transfer-encoding: quoted-printable
- Content-type: text/plain; charset=ISO-8859-1
- Reply-To: <[email protected]>
- Sender: [email protected]
The familiar lower rear wing (below the rear bumper) tin worm has attacked I cannot find any repair panels (correct?) and parts need fabricating The area is about 9 inches high from the boot floor and a local garage has quoted 340 pounds for both which seems a lot Any experiences, ideas. suggestions welcome
-- END included message