Re: clutch hydraulics

To: [email protected]
Subject: Re: clutch hydraulics
From: [email protected]
Date: Mon, 12 Apr 1999 19:49:25 EDT
CC: [email protected]
Content-Transfer-Encoding: 7bit
Content-Type: text/plain; charset="us-ascii"
Reply-To: [email protected]
Sender: [email protected]

In a message dated 4/9/99 7:48:30 AM Central Daylight Time, 
[email protected] writes:

<< I don't think that any tweaks to the slave cylinder will help a slipping
 clutch. It sounds like the spacers were put in to take up excessive play
 in the operating mechanism (a common stag problem).
 
 I can't help on the issue of the correct length of the master cylinder
 pushrod, it sounds like you need a new or straight secondhand one. If it
 is bent it will cause the bore to wear on one side and then leak.
 
 Regards,
 
 Dave. >>


Thanks, Dave.  That's some good information that I didn't have before.  I did 
find a used pushrod; I'll post the correct length FWIW.

Frank M

Prev by Date: regarding the plate covering the hole in the cabin floor
Next by Date: Re: more stag questions
Prev by thread: Re: clutch hydraulics
Next by thread: brake MC
Index(es):
- Date
- Thread

Home | Archive | Main Index | Thread Index