Re: Fuel Pump

["Brian A.Tink" <batink@domain.elided>]

MArk

Greetings from Canberra.

Fuel pumps are pretty easy to fix.

Providing the shaft moves up and down through the body all is well.
For a total rebuild, a new set of contacts, + a new diaphram + new washers and one is laughing.

The secret to success is how these units are put back together.  My Stag manual says to screw the shaft into the contacts until they WILL NOT roll over and then back off 6 holes.  No worries about this.

What it does NOT tell you, and this is something that I learnt many years ago when I had a 1960 Morris major which uses the same pump, is that when the base is clamped down the diapham must be pre-streched.

To do this, raise the contacts to their maximum lift using a wedge, screw driver, etc., and then clamped the base tight.

Otherwise there is not enough movement in the diaphram and the contacts will not roll-over.

keep staggering   Brian


At 02:04 PM 16/10/98 -0400, you wrote:
>It looks as if I will be in the market for a fuel pump.  Where
>domestically (US) can I get one and what is a reasonable price?  I may
>be able to salvage the one from my parts car, but I am not counting on
>it working, as the car has been sitting for several years.  What is
>involved in rebuilding the fuel pump?  Anyone ever done it?  Also, (I
>know this has been addressed in the past) my mechanic is tellling me
>that the stainless steel exhaust units do not fit as well as the
>original spec units and are much more prone to rattle as they do not
>hang as well as the originals.  Any opinions on this subject?  Not to be
>too na�ve (I have long since blown my cover), but what exactly is the
>difference between a small bore and large bore exhaust system?  
>
>Hoping to be Staggering by the year 2000 (and more than a bit cynical at
>this point.......)
>
>
>Mark Weir
>
>
>
>