Re: boot backboards

[Glenn Merrell <gmerrel@domain.elided>]

Hello Richard,

    The "boot backboard" I imagine you refer to is P/N 719001.  The
screws P/N 575939 are chrome plated screws that can be purchased at any
good hardware store, and attach the backboard to the back of the boot
metal.  The screws range from size #6, #8, #10 1/2 inch long.  get an
assortment of each, you will use them.  Holes should be drilled there
for the screws.  There should be cutouts for the tail lights, if not,
remove the tail lights, hold the backboard in place temporarily with a
couple of screws, trace the outline of the tail light hole onto the
cardboard and cut it out with a good razor knife.  The plastic tail
light covers, P/N 717051, attach to a bracket on the tail lights, and to
a spirenut clip P/N FU2534 pressed onto the backboard.

Hinge covers are again cardboard with carpet covers, the board pieces
are P/N 627781 and 627791 (R/L) with carpet pieces, and also attach with
the chrome plated screws.