Erratic Clock (Not OBC) -- FAQ fix successful

[Tony Canike <canike@xxxxxxxxx>]

Well, today was the planned day to put in the front cam seal and fix that 
annoying oil leak.  Thanks to Henri and Alex for the suggestions and 
pointers.  But I just wasn't up to 4 hours work to put in a $8 piece of 
rubber today.....so instead I took care of a lot of little stuff.

Sy Choudhury's fix cured my erratic clock.  (FAQ 15.7.7:   Fixing Erratic 
Clock (not OBC)).  Thank you Sy - that clock's been a mess for the last 6 
years.

Not only did I remove and resolder the multi-pin connector as per the FAQ 
,  I also resoldered the ambient light sensor and the 12hr/24hr/degC/degF 
selector switch, curing problems in those areas too.   The bad solder 
joints had a lot of flux around them - bet they didn't clean the flux off 
during manufacturing.  I did try just reheating the old solder, but that 
didn't work.  A complete removal per the FAQ did the trick.

Yes, I did hit it with flux remover when I was done.

Off for some beer.....

Tony

87 325 (eta)  209K

------------------------------