[Prev][Next][Index][Thread]

<E30> '89 325i Headlight bulb replacement

Operating System: SunOS 4.1.4 1
X-Mailer: ELM [version 2.4 PL22]
MIME-Version: 1.0
Content-Type: text/plain; charset=US-ASCII
Content-Transfer-Encoding: 7bit
Content-Length: 1357      

If you just need to replace the bulb, just pull the black plastic
shield out from behind the headlights, give the bulb a 1/4 twist and 
it's out!.  Insert new pulb using a cloth to prevent hand oil from getting
on the halogen bulb, installation is the reverse.  Takes me less than
5 minutes.

BTW My front left went out a week after the front right, so I'd 
change them both at the same time.

This only applys to '88-'89 E30's with elipsoidal(sp?) headlights,
and may apply to E34's and E32's with similar headlights.

Dale

> Following the Bentley's manual, I found that you need to remove the front   
> grill and
> take out the lens assembly to get at the bulb in the back...The grill was   
> easy, but
> lens assembly removal was a nightmare!  There are 3 plastic "clip   
> thingys" that you are
> supposed to "heat with a heat gun" to allow you to "remove the lens   
> assembly".
> Not at all easy, and I ended up trashing all 3 to get the assembly off so   
> I could replace
> the bulb.

> Chuck Huston
> [email protected]



- -- 

                        -----------------------------------
                       |            Dale Beuning           |
                       |       email: [email protected]     |
                       | web: http://www.eskimo.com/~dalus |
                        -----------------------------------