[alfa] liner-block clearance

[Mark Patterson <mrpfiat@xxxxxxxxx>]

I just put new liners in my 1750, and they have much
more clearance (~0.018") above the block than the spec
(0.002").  The clearance is pretty consistent across
all of them.  But I have them just sitting in there,
rather than being pushed down with a washer-pipe
combo.  Should the measurement be made with them
pushed down?  (I don't know if the o-ring could be
holding them up a bit.)  How much clearance is too
much?

Mark

__________________________________
Do you Yahoo!?
Yahoo! Mail - More reliable, more storage, less spam
http://mail.yahoo.com
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided