RE: 84 GTV6 Speedo

To: "John Katos" <[email protected]>, <[email protected]>, <[email protected]>
Subject: RE: 84 GTV6 Speedo
From: "Brian Shorey" <[email protected]>
Date: Fri, 19 Apr 2002 14:48:17 -0400
Content-transfer-encoding: 7bit
Content-type: text/plain; charset="iso-8859-1"
In-reply-to: <[email protected]>
Reply-to: "Brian Shorey" <[email protected]>
Sender: [email protected]

> Did you check the needle for warping? Quite often the speedo and tach
> needles on GTV6 will warp enough to stick.
>
> John Katos
> West Dundee, IL USA
>
> >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
> Speedo was working intermittenly and replaced sender in transaxle with no
> result (Difatta said should be right one and speedo itself may be dead).
> Any ideas?  Fuse?  Connections? Thanks, Bob in upstate New York

If it's not the needle, you might check the internal circuit board.  I have
seen more than one GTV6/Milano gauge with intermittent problems that turn
out to be cold solder joints on the main circuit board.

bs

--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to [email protected]

References:
- RE: 84 GTV6 Speedo
  - From: "John Katos" <[email protected]>

Prev by Date: RE: Need oddball screw
Next by Date: RE: Converting a left hand drive (European spec) 156 for use in the UK
Previous by thread: RE: 84 GTV6 Speedo
Next by thread: ABS Sensor
Index(es):
- Date
- Thread

Home | Archive | Main Index | Thread Index