steering idler arm rebuild

To: [email protected]
Subject: steering idler arm rebuild
From: [email protected]
Date: Tue, 09 Apr 2002 14:17:20 -0400
Content-transfer-encoding: 7bit
Content-type: text/plain; charset=iso-8859-1
Reply-to: [email protected]
Sender: [email protected]

Hello Ed:

I would suggest drilling a hole through the bottom of the spindle and up the center and another hole at 90 degrees to the spindle so as to meet the first hole and between the two bushes in the housing. Then fit a grease nipple at the bottom of the spindle. I dont know the clearance but I would suspect that with grease in the housing there should be no sideways play. Isn't the housing aluminium? I wouldn't put a grease fitting in it.

Best regards,

Nash Bapasola
AROC NJ

--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to [email protected]

Prev by Date: 78 Spider: Where do these vacuum hoses go!
Next by Date: Auto recall site
Previous by thread: steering idler arm rebuild
Next by thread: GTY FLASHER UNIT
Index(es):
- Date
- Thread

Home | Archive | Main Index | Thread Index