Update: New stepper gears not turning freely

[Jerry Ecklund <jre2100@domain.elided>]

This was my mistake.  After replacing the gears in the
second unit and both acting the same I realized it's
ok for the output shafts to be stiff so long as they
move freely when turning the input gears.  I've
connected the unit to the wiring harness and all is
well.

Thanks,
Jerry

Date: Wed, 13 Feb 2002 15:31:04 -0800 (PST)
From: Jerry Ecklund <jre2100@domain.elided>
Subject: New stepper gears not turning freely

Hello listers,

It's me again with more stepper repair problems.  I've
cleaned and regreased one of the stepper gearbox
assembly and installed new metal Alfapro gears.  The
gears turn well with the cover off but once I install
the cover with the final output gear attached it's
almost seized.  I feel like quite the idiot not being
able to figure this one out.  Any suggestions?  Sound
familiar?

Thanks,
Jerry, San Francisco
'91 164S
Send FREE Valentine eCards with Yahoo! Greetings!
http://greetings.yahoo.com

--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided