Re: alfa-digest V8 #154 - '87 Spider heater fan

[AlfaNeely@domain.elided]

       Down by the foot feed on the side of the heater, there are two wires 
plus a black ground wire.  Switch the two wires and see if the low side works.
       You might have to remove the driver's side of the console to get to 
the wires.  That will depend on model.
       The most common problem with the blower fan is it is at the bottom of 
the heater.  Water enters through the cowl vent and runs down to ruin the 
motor.  Be glad yours works at all.
       Removal of the heater to get the fan out is a pain.  There are four 
tiny bolts up under the cowl that holds the heater in place.  Search the 
archives for information on heater removal.  Or ask and I can write something 
again.

Ciao,
Russ Neely
Oklahoma City

In a message dated 10/19/2001 5:40:30 PM Central Daylight Time, 
owner-alfa-digest@domain.elided writes:






> Date: Fri, 19 Oct 2001 11:57:40 -0500
> From: "Christopher Sasso" <csasso@domain.elided>
> Subject: '87 Spider heater fan
> 
> Hi All,
> 
> The blower for the heater in my Spider only operates on high.  Is this 
> likely
> to be a problem with the switch or the blower unit itself?  Any suggestions
> are  appreciated.
> 
> Chris
> Sacramento, CA

--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided